Model - Taylor 8756 Operator's Manual

Step 2
Install the drive shaft through the rear shell bearing
in the freezing cylinder and engage the hex end
firmly into the gear box coupling. Be sure the drive
shaft fits into the drive coupling without binding.
Figure 8
USE EXTREME CAUTION when handling
the beater assembly. The scraper blades are very
sharp and may cause injury.
Step 3
Before installing the beater assembly, check the
scraper blades for any signs of wear or damage. If a
scraper blade is nicked or worn, replace both
blades.
Figure 9

Model 8756

Step 4
If the blades are in good condition, place the rear
scraper blade over the rear holding pin on the
beater. The hole on the scraper blade must fit
securely over the pin to prevent costly damage.
Note: Scraper blades should be replaced every 3
months.
Step 5
Holding the rear blade on the beater, slide it into the
freezing cylinder half way. Install the front scraper
blade over the front holding pin.
Step 6
Before installing the beater shoes, check the shoes
for any nicks, cracks, or signs of wear. If any defects
are present, replace the beater shoes.
17
Figure 10
Figure 11
160701
Operating Procedures