Chip Extraction; Saw Blade Selection; Saw Blade Change; Riving Knife/Splitter - Mafell KSS 60 36B Original Operating Instructions

Do not use force to do so.

4.4 Chip extraction

Danger
Substances that are harmful to
health must be taken up with an M-
suction device.
Connect the machine to a suitable external dust
extractor during all work generating a considerable
amount of dust. The air velocity must be at least 20
m/s (65.6 ft / sec.).
The inside diameter of hose connector 1 (Fig. 3) is 35
mm (1 3/8 in.).

4.5 Saw blade selection

Use a sharp tool to obtain a good cut quality and
select a tool from the following list according to
material and application:
For cuts especially along the grain in soft or hard
wood:
- Circular saw blade carbide Ø 185 x 1.8 x 20 mm,
16 teeth
For cuts especially across the grain in soft or
hard wood:
- Circular saw blade carbide Ø 185 x 1.8 x 20 mm,
32 teeth

4.6 Saw blade change

Danger
Unplug the rechargeable battery for
all service work.

Remove the rechargeable
automatically blocks the shaft.

Using the Allen key 4 (brackets Fig. 3) release
the flange screw 5 (Fig. 3) counter clockwise.
Remove the screw and the front clamping flange
6 (Fig. 3).

Now you can remove the saw blade after
opening the retractable saw guard.

The clamping flanges must be free of adhering
parts.

Pay attention to the sense of rotation when
inserting the saw blade.

Afterwards, mount the clamping flange, attach
the flange screw and tighten it by clockwise
turning.

Refit the rechargeable battery.

4.7 Riving knife/splitter

The riving knife 7 (Fig. 3) prevents the saw blade
from jamming during longitudinal cutting. The correct
distance to the saw blade is shown in (Fig. 4).

For adjustment purposes, release the screw 8
(Fig. 3) with the Allen key 4 that is included in
the supply (Fig. 3).

Adjust the riving knife/splitter by moving it in its
longitudinal groove and retighten the screw
afterwards.
5

Operation

5.1 Initial operation

Personnel entrusted to work with the machine must
be made aware of the operating instructions, calling
particular
instructions".

5.2 Switching on and off


Switching on: First press the lock-off button 9
(Fig. 2), then activate the switch trigger 10 (Fig.
2).

Switching off: For switching off, release the
switch trigger 10 (Fig. 2).
battery. This

5.3 Cutting depth adjustment

The cutting depth is continuously variable between 0
and 66 mm.
Proceed as follows to adjust it:

Unfasten the clamping lever 12 (Fig. 1).

Set the cutting depth with the plunge lever 13
(Fig. 1).
-23-
Danger
Unplug the rechargeable battery for
all service work.
attention to the chapter "Safety