Change The Idrac Network Port - Dell EMC PowerProtect DD9900 Installation Manual

Configure System for Use
5. Click Apply to save any changes.
6. Select iDRAC Settings
7. Specify the following values if they are not already configured:
8. Click Apply to save any changes.
9. Select iDRAC Settings
10. Specify the following values if they are not already configured:
11. Click Apply to save any changes.
12. Select Configuration
13. Click Apply and Reboot.
14. Select Maintenance

Change the iDRAC network port

About this task
iDRAC provides the ability to disable the dedicated iDRAC Ethernet port and assign the iDRAC
connection to share one of the network daughter card Ethernet ports. This step is optional.
Procedure
1. Connect to the system serial console or connect KVM to the system.
2. Reboot the system.
3. During the system boot process, press
4. Select iDRAC Settings.
5. Select Network.
Dell EMC PowerProtect DD9900 System Installation Guide
74
Serial Communication: Auto
l
Serial Port Address: Serial Device1=COM2, Serial Device2=COM1
l
External Serial Connector: Serial Device 2
l
Failsafe Baud Rate: 115200
l
Remote Terminal Type: VT100/VT220
l
Redirection After Boot: Enabled
l
Enable Serial Over Lan: Enable
l
Baud Rate: 115.2 kbps
l
Channel Privilege Level Limit: Administrator
l
Redirect Enable: Enable
l
Escape Key: ^\ (
Ctrl + \
l
a. Select Enabled for SSH.
b. Verify the Port Number is set to 22.
complete.
Note: Click Refresh to get the latest status
CAUTION Do not configure iDRAC to use network daughter card ports 2, 3, and 4, as they are
reserved for the HA interconnect.
Connectivity Serial Over LAN.
> >
)
Services.
>
BIOS Settings Serial Communications.
> >
Job Queue and verify the Configure: BIOS.Setup job is
>
to access the BIOS menu.
F2