Network Software Ports Needed To Support Dlm Disaster Recovery Testing; Installation Information; Required Network Port For Disaster Recovery Testing - Dell EMC DLm8500 Data Domain Physical Planning Manual

Network software ports needed to support DLm Disaster
Recovery Testing

Installation information

Table 2 Required Network Ports for DLm Operations (continued)
Port Port Type
Number
636 TCP/UDP
5432 TCP/UDP
9443 TCP
This section describes about requirement of network software ports to support DLm
disaster recovery testing.
To perform DLm Disaster Recovery testing on a mainframe and to allow the mainframe
to write data to the back-end storage, you must configure your firewall to allow traffic
on particular network ports that are different for each back-end storage system type.
The following table lists the special port for Disaster Recovery testing for the various
DLm models:
Table 3 Required Network Port for Disaster Recovery Testing
DLm Port Number
Model
DLm8500 9050
with
PowerMax
DLm8500 9060
with Data
Domain
DLm8500 2051
with Data
Domain
This section contains all the installation-related information.
Discuss and obtain the following site profile information from the Dell EMC Sales
Representative.
The following table lists the external dependencies that need to be considered for
configuring DLm systems.
Disk Library for mainframe Physical Planning Guide for DLm8500
Protocol(s Traffic User Direction of
)
LDAP Secure LDAP
LDAP PostgreSQL
Database
TCP GUI/
Communicatio
n
Port Type Traffic
User
TCP DLMDRD/D
Lm disaster
recovery
TCP DLMAUT
TCP Replication
Configuration and host connectivity
Notes
Traffic
Inbound/ N/A
Outbound
Inbound/ N/A
Outbound
Outbound To SRS
Direction Notes
of Traffic
Outbound DR to
maintain
Inbound/ DR to
Outbound maintain
Inbound/ Proprietary
Outbound protocol
17