Enable Administrative Communication; Idrac Nic To Physical Port Mapping; Communications Settings - Dell EMC PowerProtect DD9900 Installation Manual

6. Under Network Settings, change NIC Selection from
7. Press Esc to return to the previous menu.
8. Exit the BIOS menu and reboot the system to allow the change to take effect.

Enable administrative communication

The serial port and dedicated iDRAC9 dedicated management port at the rear of the system are
the only supported interfaces for console access. Do not connect to the USB and iDRAC direct
micro-USB port on the front of the system.
Use the following settings:
Table 14 Communications settings
Setting
Baud rate
Data bits
Stop bits
Parity
Flow control
Emulation
Establish a serial connection
1. Connect the DB-9 cable to the serial port on the back panel of the system (#2 in the figure
2. Launch a terminal emulation program from your computer and configure the following
values:
Table 13 iDRAC NIC to physical port mapping
iDRAC NIC selection
LOM1 - [NIC Integrated 1-1-1]
LOM2 - [NIC Integrated 1-2-1]
LOM3 - [NIC Integrated 1-3-1]
LOM4 - [NIC Integrated 1-4-1]
above).
communication settings:
Physical network port
Network daughter card port 1
Network daughter card port 2
Network daughter card port 3
Network daughter card port 4
Value
115200
8
1
None
None
VT-100
Dell EMC PowerProtect DD9900 System Installation Guide
Configure System for Use
to one of the following
Dedicated
75