Table of Contents
Advertisement
Configure System for Use
Configure iDRAC
About this task
The PowerProtect system requires that the Integrated Dell Remote Access Controller (iDRAC) is
configured for system upgrade and maintenance operations. Additionally, the system supports the
use of iDRAC to change security settings, and remotely power the system on and off.
Procedure
1. Connect to the system serial console or connect KVM to the system.
2. Reboot the system.
3. During the system boot process, press
4. Select iDRAC Settings.
5. Select Network.
6. Under IPv4 Settings, static IP address details.
7. Press Esc to return to the previous menu.
8. Select User Configuration.
Dell EMC PowerProtect DD9900 System Installation Guide
72
CAUTION
Do not use iDRAC to change the storage configuration, system settings, or BIOS
settings, as making changes will impact system functionality. Contact Support if changes are
required in any of these areas.
Note:
DHCP is not supported for the iDRAC IP address.
Note:
Press
Shift + Backspace
connections with VT100+ keyboard emulation.
Figure 64 iDRAC Settings > Network
a. Enable the root user.
b. Change the root user password.
to access the BIOS menu.
F2
to delete an existing IP address value over
Hide quick links:
Advertisement
Table of Contents
