Idrac Direct Led Indicator Codes - Dell EMC VxRail E Series Owner's Manual

Overview
Table 10 DC PSU status indicators (continued)
Convention
D

iDRAC Direct LED indicator codes

The iDRAC Direct LED indicator lights up to indicate that the port is connected and is being used
as a part of the iDRAC subsystem.
Figure 10 iDRAC Direct LED indicator
1. iDRAC Direct status indicator
The following table describes iDRAC Direct activity when configuring iDRAC Direct by using the
management port (USB XML Import).
This table describes the iDRAC Direct status indicators and what is the condition when the LED
flashes green, continuously flashes green and when it's not lit.
Dell EMC VxRail Appliances on PowerEdge Servers E Series Owner's Manual
16
Power indicator
pattern
Not lit
Note: The iDRAC Direct LED indicator does not turn on when the USB port is used in the USB
mode.
Condition
the PSU to make a matched pair can result in an
error condition and unexpected appliance shutdown.
To change from a High Output configuration to a
Low Output configuration or vice versa, you must
turn off the appliance.
CAUTION If two PSU are used, they must be of the
same type and have the same maximum output
power.
CAUTION Combining AC and DC PSU is not
supported and triggers a mismatch.
Power is not connected.