Configure Idrac; Installing The Dataprotection-Acm Pre-Installation Patch - Dell EMC DP4400 Hardware Installation Manual

Hardware Installation Guide

Configure iDRAC

The IDPA systems require that the Integrated Dell Remote Access Controller (iDRAC) is
configured for system upgrade and maintenance operations. Additionally, the systems support the
use of iDRAC to change security settings and enables to remotely power the system on and off.
Before you begin
Connect to the unit using a VGA monitor with a keyboard or a serial port, power on the appliance,
and perform the following steps:
Procedure
1. During the system boot process, press F2 to access the BIOS menu.
2. In the System Setup Main Menu page, click iDRAC Settings.
3. Click Network.
4. Under IPv4 Settings, specify static IP address details.
5. Press Esc to return to the previous menu.
6. Select User Configuration.

Installing the DataProtection-ACM pre-installation patch

Before you configure the DataProtection-ACM virtual machine, install the latest IDPA pre-
installation patch if it is available.
For example:
Idpa_pre_update_N.N.N-nnnnnn.tar.gz
Where
You can install the pre-installation patch when the DataProtection-ACM is not registered with
Secure Remote Services gateway by using SSH.
Dell EMC Integrated Data Protection Appliance DP4400 2.4 Hardware Installation Guide
12
Note: Do not use iDRAC to change the storage configuration, system settings, or BIOS
settings, as making changes to these will impact the system functionality. Contact Support if
changes are required in any of these areas.
The iDRAC Settings page is displayed.
The Network page is displayed.
a. Enable the root user.
b. Change the root user password.
Note that the default password is Idpa_1234 .
N.N.N is the latest pre-installation patch version and nnnnnn is the build number.