Table of Contents
Advertisement
Configure System for Use
Configure HA
Before you begin
l
l
About this task
Configure the two nodes as an HA pair.
Procedure
1. Verify the certificate subject name on the primary node.
Dell EMC PowerProtect DD9900 System Installation Guide
92
Figure 66 iDRAC power options
The HA interconnect between both nodes is connected.
Note:
Connecting the HA interconnect
interconnect.
The data connections on both nodes are connected.
Note:
Configuring an HA pair sets the system password on the standby node to match the
system password on the active node, however, that synchronization is not set until the HA
configuration is complete. If the HA configuration fails, or if there is a need to access either
node before the HA configuration is complete, use the serial number of each node as the
password.
Run the following command:
on page 66 describes how to cable the HA
Hide quick links:
Advertisement
Table of Contents
