Datafox ZK-MasterIV Manual page 82

Manual Datafox ZK-MasterIV
zum
TS-TMR33-LTM
Figure 57: Connection of the ZK-MasterIV
vom ZK-MasterIV
zum
TS-TMR33-TM
Figure 58: Connection and configuration of the TS TMR33-LTM for RS485
In this example, the door opener is connected via PIN 6 (open-collector -) and PIN 7 (open-collector
+). The power is provided by the module. An additional voltage source is not necessary. However, you
have to observe that the door opener has to work within a voltage range of 8 to 12 V DC and that the
current consumption has not to exceed 100 mA. Otherwise , the door opener can also be switched via the
relay. In that case, a voltage/ switching current of 42 V AC/0,5 A or 60 V DC/0,3 A at most is permissible.
Version: 04.01.07.00
RS232 an PC
11
P16
1
Page 82
The power supply for the ZK-MasterIV and the
access modules (TS TMR33) is established via the
red wire (12 V DC) and the blue wire (GND). Note
the information in chapter 3.2.1. The RS485 bus
is connected via the yellow wire (data line A =
+) and the grey wire (data line B = -). The 3 A
power supply unit is connected to the cabling via
an additional distribution box.
The bus no. is set on 0 via the DIP switch on the
door module with a reader (TS TMR33-LTM); the
DIP switches 1 to 5 have to be at OFF. The DIP
switch 7 always has to be at OFF. The module is
not the last module in the RS485 bus. Therefore,
the DIP switch 8 has to be at OFF. The power
supply is established via PIN 10 (GND) and 11 (8
- 14 V DC) of the edge connector P16. The RS485
data channel A (+) is connected via PIN 8 and the
data channel B (-) via PIN 9.
www.datafox.de