Table of Contents
Advertisement
Manual Datafox ZK-MasterIV
Figure 12: RS232 auf RS485 Bus
Connect the converter to the PC with a Sub-D 9-pole 1:1 cable as shown in figure 11. The converter
replaces the ZK-MasterIV.
Figure 13: RS485 Bus über RJ45 (RS485A HW V 1.4)
PIN 3/4 and 5/6 are bridged in the device and makes it possible to loop the bus through. PIN 7/8 in
figure
13
and PIN 1/4 in figure
bus possible.
Figure 14: RS485 Bus über Stiftleisten (RS485A HW V 2.0)
Caution:
If the power supply of the ZK-MasterIV and the RS485 bus is established via PIN
7/8 (RJ45 connection of the ZK-MasterIV in figure 13) or PIN 1/4 (male connector
of the in figure 14) direct voltage must be used (see chapter 3.2.1).
Version: 04.01.07.00
14
are supply entries which make a power supply of the device via the
Page 26
www.datafox.de
Advertisement
Table of Contents
