Training Interruption/End; Training Resumption; Recovery Pulse Measurement - Kettler SM 3290 Training And Operating Instructions

Training Interruption/End

If there are less than 10 pedal revolutions/minute or
"RECOVERY" is pressed, the electronics recognise a trai-
ning interruption. The training data achieved is displayed.
Speed, exertion, revolutions and pulse are displayed as
average values with the Ø -symbol with a "+" or "–"
change in the current display, e.g. rest values. The trai-
ning data is displayed for 4 minutes. If you do not press
any keys during this period and do not train, the electro-
nics switch into the snooze mode with the room temperatu-
re is displayed.

Training Resumption

If training is continued within 4 minutes the last values are
counted further or downwards.
RECOVERY – Function

Recovery Pulse Measurement

At the end of training press "RECOVERY".
The electronics measure your pulse for the last 60 seconds
retrospectively.
If you press "RECOVERY", the current pulse value is saved
under "RPM" and the pulse value is saved after 60
seconds under "SPEED". "DISTANCE" displays the diffe-
rence between the two values.
This results in a fitness mark (Example F 2.6). The display
stops after 20 seconds.
"RECOVERY" or "RESET" interrupts the function
Comment
If no pulse is recorded at the start or end of the time peri-
od, an error message is displayed.
27
GB