Fcc Registration Information - IDTECK SR10RW User Manual

☞.When card reads, Read Range of every card differ.
Although same formatted card, specific character of card classified by manufacturing
Cause
company differs. (Reader of IDTECK is tuned by standard Phillips Mifare™ Card.)
1. Unique character of coil and manufacturing process by card manufacture
company decide unique card character. So confirm using card to manufacture in
same company. If card made in several kinds of manufacturing company, every
Solution
card which comes out Read Range differently is normal operation.
2. If Read Range differs every reading time of card despite same card manufacture
company, contact RMA center.

12. FCC Registration Information

FCC REQUIREMENTS PART 15
Caution: Any changes or modifications in construction of this device which are not expressly approved by
the manufacturer for compliance could void the user's authority to operate the equipment.
NOTE: This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions;
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B Digital Device,
pursuant to Part 15 of the FCC Rules. These limits are designed to this equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
radio or television off and on, the user is encouraged to try to correct interference by one or more of the
following measures.
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on another circuit.
4. Consult the dealer or an experienced radio/TV technician for help.
15