Mounting With Adhesive Strips - HomeMatic HM-PB-4Dis-WM Mounting Instruction And Operating Manual

• First of all, mark four bore hole positions (a)
on the wall. When you hold the mounting
plate against the wall, the inscription "top"
must be visible at the top edge.
• If you are working with a stone wall, drill four
5 mm holes and insert the plugs supplied. If
you are working with a wooden wall, you can
pre-drill 1.5 mm holes to make the screws
easier to insert.
• Screw the screws in.
• Then slide the wall-mounting pushbutton
onto the holder from above.
If you want to install the wall-mounting
pushbutton above other pushbuttons,
switches or sockets that are already in place,
you must bear in mind the fact that current lines
usually run upwards. This means there is a risk of
electric shock. In such cases you should attach the
wall-mounting pushbutton with adhesive strips.

7.2 Mounting with adhesive strips

To attach the wall-mounting pushbutton with adhe-
sive strips, proceed as follows:
• Select a mounting location.
• Attach the adhesive strips to the rear of the
mounting plate (not on the side where the word
44