Otto Bock 1C62 Triton Harmony Instructions For Use Manual page 32

replace the valves. Blow any accumulated debris out of the Functional Ring using compressed
air while the valves are removed.
When replacing the functional ring at the recommended service interval, wipe all old grease
from the shaft and bearings, apply new grease, and replace the two o-rings on the shaft. These
o-rings do not affect vacuum performance. They are used to cushion undesirable but necessary
movement in the bearing system.
5 Legal information
All legal conditions are subject to the respective national laws of the country of use and may vary
accordingly.
5.1 Liability
The manufacturer will only assume liability if the product is used in accordance with the descrip-
tions and instructions provided in this document. The manufacturer will not assume liability for
damage caused by disregard of this document, particularly due to improper use or unauthorised
modification of the product.
5.2 CE conformity
This product meets the requirements of the European Directive 93 / 42 / EEC for medical devices.
This product has been classified as a class I device according to the classification criteria outlined
in Annex IX of the directive. The declaration of conformity was therefore created by the manufac-
turer with sole responsibility according to Annex VII of the directive.
32 | Ottobock