Page GB-26
Mounting the front panel
Mounting the front panel
You can mount a front panel on the dishwash-
er which matches your kitchen. The front pan-
el must not exceed a weight of 7 kg.
1. Lay the supplied drilling template on the
reverse side of the front panel in such a
way that the drilling template and the front
panel are flush at the top.
2. Transfer the drill holes from the drill tem-
plate to the front panel.
3. Drill the drill holes in the indicated posi-
tions using a (Ø 2 mm) drill bit.
(m)
(l)
(g)
4. Affix both installation hooks (m) with four
screws (g) each (4×14 mm) onto the front
panel.
5. Affix both mounting pegs (l) using the
screws (i) (3.5×25 mm) onto the front
panel.
(i)
(l)
6. Hang the front panel on the door of the
(m)
dishwasher, hold it in place and open the
door carefully.
(k)
7. Remove the 4 screws from the inside of
The front panel is then mounted.
1/2
P1
P2
P3
ECO
P4
P5
P6
the door. Screw the front panel to these
positions with the help of the attached 4
screws (k).
(k)