Mounting The Front Panel - Hanseatic HGTI6082D137709HS User Manual

Page EN-32

Mounting the front panel

You can mount a front panel on the dishwash-
er which matches your kitchen. The front pan-
el must not exceed a weight of 7 kg.
1. Hold the front panel against the dish-
washer door such that the lower side of
the front panel is flush with the adjoining
kitchen cupboards.
2. Measure the distance between the front
panel and the control panel.
(d)
3. A gap of 5 mm to 25 mm can be offset
with the 5 trim strips (d) included. Re-
move the required number of trim strip
from the block. To do so, move the
moulding vigorously but without using
tools.
4. If you only need one trim
strip, saw off the four feet
that stick out, clamp the
trim strip under the control
panel and secure it using
both countersunk screws (k).
Continue with Step 7.
5. If you need more than one trim strip, turn
the lower trim strip and push it onto the
other trim strips. This hides the feet and
makes the surfaces flat.
Installation, connection and starting-up
6. If you
– need 2 trim strips, secure these using
both countersunk screws (l).
– need 3 trim strips, secure these using
both countersunk screws (m).
– need 4 to five 5 strips, secure these
using both countersunk screws (n).
(f)
7. Pull the two pairs of velcro straps (f)
apart.
8. Remove the protective film from the
same type of velcro strap.
Intensive Glass
Normal 1 Hour
ECO Rapid
On/O
Programs
(f)
9. With the protective film removed, affix
the velcro straps (f) to the middle of the
recessed areas on the dishwasher door.
10. Cut the positions of the Velcro straps out
of the drilling template.
11. Cut the number of trim strips used off the
drilling template.
9h
6h
3h
Delay
Start/Pause