Mounting The Front Panel - Hanseatic HGTI6082C147735TS User Manual

Page EN-32 Set-up, connection and initial start-up
5. Remove the protective films from the side
end profiles (d).
6. Affix the end profiles to the left and right
edges of the dishwasher.
This will prevent a crack being visible be-
tween the dishwasher and the adjacent
kitchen cupboards.
7. Push the dishwasher into the recess.
(48)
(42)
8. To position the dishwasher so that it is
level, the two front adjustable feet (42)
and the back foot on the appliance can be
adjusted by up to 50 mm.
– The front feet are equipped with slots.
Insert a screwdriver into one of the slots
and turn the feet to the height required.
– You can adjust the height of the rear
adjustable foot with the centre adjusting
screw. Use a Phillips-tip screwdriver for
this.
9. Check the alignment with a spirit level.
10. Make sure the top edge of the dishwash-
er is level with the bottom edge of the
worktop to prevent it from tipping forward
when you open the door.
(d)
11. Screw the dishwasher to the kitchen
unit.
– If you have granite worktops, remove
– For all other worktops, screw the mount-

Mounting the front panel

You can mount a front panel on the dishwash-
er door which matches your kitchen. The front
panel must not exceed a weight of 5 kg.
(e)
(j)
(f) (i)
the internal side cover caps (f) and
screw the dishwasher to the adjacent
kitchen cupboards.
Re-cover the screws (i) with the cover
caps.
ing bracket (e) firmly to the worktop.
If you do not have a front panel on the
appliance, please read on from "Ad-
justing the door's accessibility" on
page EN-34.