Mounting The Front Panel - Hanseatic HGU6082B14U7735ES User Manual

Page EN-36 Installation, connection and initial commissioning
2. Re-cover the screws (44) with the cover
caps.
For all other worktops:
• For all other worktops, screw the mount-
ing bracket (40) firmly to the worktop.

Mounting the front panel

A front panel must only be used for the model
with the item number 44253453.
You can mount a front panel on the appliance
door which matches your kitchen. The front
panel must not exceed a weight of 5 kg.
1. Hold the front panel against the dish-
washer door such that the lower side of
the front panel is flush with the adjoining
kitchen cupboards.
2. Measure the distance between the front
panel and the control panel.
(41)
3. A gap of 5 mm to 25 mm can be offset with
the 5 mouldings supplied (41). Remove
the required number of moulding from the
block. To do so, move the moulding vigor-
ously but without using tools.
4. If you only need 1 moulding, saw off the 4
protruding feet, clamp the
moulding under the control
panel and secure it using
b o t h c o u n t e r s u n k
screws (46).
5. Continue with Step 7.
6. If you need more than 1 moulding, turn
the lower moulding and push it onto the
other mouldings. This hides the feet and
makes the surfaces flat.
7. If you
– need two mouldings, secure these us-
ing both countersunk screws (46).
– need three mouldings, secure these
using both countersunk screws (47).
– need four to five mouldings, secure
these using both countersunk screws
(48).
(42)
8. Pull apart the two pairs of velcro
straps (42).
9. Remove the protective film from the same
type of velcro strap.
10. With the protective film removed, stick the
Velcro straps onto the middle of the re-
cessed areas on the appliance door.
11. Cut the positions of the Velcro straps out
of the drilling template.
12. Cut the number of mouldings used off the
drilling template.
(42)