Table of Contents
Advertisement
Configuration Using the Phone Menus
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: (0)330 088 0195 Fax: +44 (0)1245 808299
3. Press
or
to select the network mode for your network type, and then press
Save
.
DHCP (IPv4) or Auto (IPv6) is enabled by default, which means the VSP726A will get its IP
address from the network. When DHCP and Auto are disabled, you must enter a static IP
address for the VSP726A.
You must be familiar with TCP/IP principles and protocols to configure static IP
settings.
To set static IP for the VSP726A:
1. From the Mode menu, press
If DHCP is disabled, the Set static IP menu appears. If DHCP is enabled, an error
message appears briefly before returning you to the Network setting menu.
2. On the Set static IP menu, enter the static IP address. Use the dial pad and the
Add dot
soft key to enter characters. Press
3. Press
and enter the Subnet Mask. Use the dial pad and the
enter characters. Press
and enter the Gateway. Use the dial pad and the Add dot soft key to enter
4. Press
characters. Press
or
5. Press
and enter the IP address for the primary DNS server. Use the dial pad and
the
Add dot
soft key to enter characters. Press
character.
6. Press
and enter the IP address for the secondary DNS server. The VSP726A uses
this server if the primary server does not respond.
7. Press
Save
.
To set static DNS:
1. From the Network setting menu, press
(whichever is in use in Static mode), and then press SELECT.
2. Highlight Set static DNS and then press SELECT.
The Set static DNS menu appears.
VSP726A Administrator and Provisioning Manual
to select Static IP, and then press SELECT.
or
or
or
to advance to the next character.
to advance to the next character.
or
33
to advance to the next character.
soft key to
Add dot
or
to advance to the next
to highlight IPv4 or IPv6
Back to Contents
Advertisement
Table of Contents
