VTech ErisTerminal VSP726A Administrator And Provisioning Manual page 85

Using the WebUI
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: (0)330 088 0195 Fax: +44 (0)1245 808299
Setting
Static IP
IP Address
Subnet Mask
Gateway
PPPoE
PPPoE Username
PPPoE password
Manually Configure
DNS
Primary DNS
Secondary DNS
IPv6
Setting
Disable
Auto Configuration
Static IP
IP Address
Prefix (0–128)
Gateway
Manually Configure
DNS
VSP726A Administrator and Provisioning Manual
Description
When Static IP is selected, you must enter a static IP
address for the VSP726A, as well as addresses for the
Subnet Mask, Gateway, and DNS Server(s).
If DHCP is disabled, enter a static IP address for the
VSP726A.
Enter the subnet mask.
Enter the address of the default gateway (in this case, your
router).
Select to enable PPPoE (Point-to-Point Protocol over
Ethernet) mode.
Enter your PPPoE account username.
Enter your PPPoE account password.
Select to enable manual DNS configuration.
If DHCP is disabled, enter addresses for the primary and
secondary DNS servers.
Description
Disables all related IPv6 settings.
Auto configuration is selected (enabled) by default, which
means the VSP726A will get its IP address, Gateway, and
DNS Server(s) from the network. When Auto Configuration is
disabled, you must enter a static IP address for the VSP726A,
as well as addresses for the Gateway and DNS Server(s).
When Static IP is selected, you must enter a static IP
address for the VSP726A, as well as an IPv6 address prefix,
Gateway, and DNS Server(s).
If Auto Configuration is disabled, enter a static IP address for
the VSP726A.
Enter the IPv6 address prefix length (0 to 128 bits).
Enter the address of the default gateway (in this case, your
router).
Select to enable manual DNS configuration.
85
Back to Contents