Download Print this page

Filling With Water - Honeywell TC10PM Series User Manual

Portable evaporative air cooler
Hide thumbs


Table of Contents


CAUTION: Unplug the unit from the electrical socket before emptying or refilling the water tank.
Open the Water Fill Door located on the back of the unit.
The Water Level Indicator is located at the front of the unit. Refill
the water tank when water level is low. Do not fill water above the
"Max." water level mark to avoid water droplets collecting on
the louvers. Check the water level in the tank before running the
COOL function. Make sure that the water in the tank is above
the minimum water level mark. Running the unit in COOL mode
with inadequate water may cause pump failure.
Note: The water capacity refers to the total volume of water that can be contained within the air
cooler water tank and water distribution system. The water capacity in the tank at the "Max." indicator
level may be lower than the actual water capacity of the air cooler.
WARNING: Do not fill water tank with dirty water or salt water. This can damage the unit and
Honeycomb media.
Below are instructions on how to clean and maintain your air cooler. If the cooler will not be used
for a long period of time, please refer to the STORAGE & MAINTENANCE GUIDELINES located in
the separate Safety & Maintenance Guide.
Before cleaning the unit, power OFF the unit and disconnect from the electrical socket.
• Move the unit to a location where the water can be drained. Remove the cap from the drain plug
located at the bottom of the unit. Allow the tank to empty.
• Refill the water tank with clean water, up to the maximum level and drain it completely.
• Use a damp cloth to remove the dirt and dust from the surface of the unit. Never use corrosive
elements or chemicals to clean this product.
• When the product is not in use, store the unit in a dry place out of direct sunlight.
Water Fill Door

Hide quick links:


Table of Contents

  Related Manuals for Honeywell TC10PM Series