Filling With Water - Honeywell CO301PC Series User Manual

USE & OPERATION (CONTINUED)
COOLER LOCATION
Make sure to position the air cooler correctly before you set up and start using the product. Please
refer to the COOLER LOCATION section of the separate Safety & Maintenance Guide.

FILLING WITH WATER

It is ideal to use the Continuous Water Supply Connection to run the unit for long periods of time
without refilling the tank. This also helps prevent pump failure in case the cooler is running with
inadequate water in the tank.
CAUTION: Unplug the unit from the electrical power outlet before emptying or refilling the water tank.
Continuous Water Supply Connection:
For a continuous water supply, you will need a garden hose that is connected to a mains water supply.
Note: The garden hose is not included. Please make use of a garden hose which is compatible with
the unit connection.
• Locate the male connector at one end of the garden hose.
Insert the garden hose connector into the water inlet valve
of the cooler. Screw and tighten the water inlet valve onto
the threaded part of the garden hose connector, making
sure the hose connector is secured to ensure there will be
no leaks. If there is a leakage, the hose and the water inlet
valve may not be connected properly. Try to disconnect,
replace and tighten the water inlet valve again.
• When the connection is secured, turn ON the water supply
and the water will flow into the water tank of the cooler.
• The cooler is now set so the water refills automatically.
• When the water tank is full of water, the water inlet valve
will automatically stop the water supply from overflowing
the water tank.
WARNING: The maximum water inlet pressure is 0.5 MPa.
Manual Water Tank Refill:
Open the Water Fill Door located on the side of the unit.
The Water Level Indicator is located at the side of the unit. Refill the water
tank when water level is low. Do not fill water above the "Max." water level
mark to avoid water droplets collecting on the louvers. Check the water
level in the tank before running the COOL function. Make sure that the
water in the tank is above the minimum water level mark. Running the
unit in COOL mode with inadequate water may cause pump failure.
EN 4
Water Inlet
Valve
Garden Hose
Water Fill Door
Water Level
Indicator