Rack Mounting The Processor - Sony MFS-2000-C Installation Manual

2-4. Rack Mounting the Processor

The processor installs in a 19-inch standard rack.
To mount the processor in a rack, use the specified rack
mount kit and follow the procedure described below.
Specified rack mount kit : RMM-10
n
If a rack mount kit other than the specified one is used, the
unit may not correctly install in a 19-inch standard rack.
Parts of the RMM-10
. Rack tools
. Right rack mount adaptor
. Left rack mount adaptor
. Rack tool attaching screws
(B4 x 6 : 7-682-560-09)
. Adaptor attaching screws
(B4 x 10 : 7-682-560-10)
Precautions for rack mounting
w
. To prevent the rack from falling or moving, fix the rack
on a flat and steady floor using bolts or other fixings.
If the rack falls due to the weight of the equipment, it
may cause death or injury.
. Be sure to use the specified rack mount kit.
If not, injury may result and the equipment may fall due
to insufficient strength.
. After rack mounting, be sure to tighten the screws on the
rack angle and fix the unit in the rack.
c
When mounting the unit in the rack, note the following:
. Be sure to mount in the rack with two persons or more.
. Be careful not to catch your fingers or hands in the rack
mount rail or others.
. Mount in the rack in a stable position.
n
If several units are mounted in a rack, it is recommended
that a ventilation fan is installed to prevent temperature rise
inside the rack.
2-6
Rack mounting procedure
This section describes the rack mounting procedure using
the RMM-10 rack mount kit.
n
Tighten the screws to the following torque.
Tightening torque : 120 x 10
1. Remove four feet as required.
2 pcs
1 pc
1 pc
6 pcs
6 pcs
Foot
2. Attach the rack tools to the side of the equipment using
_2
B4 x 8
the specified six screws.
n
Use B4 x 6 screws.
Rack tool
B4 x 6
N.m (12.2 kgf.cm)
Foot
B4 x 8
B4 x 6
Rack tool
MFS-2000 IM