Sony MFS-2000-C Installation Manual page 17

3. Loosen the screws on the rear of the right and left
adaptors and adjust the length of the adaptor according
to the depth of the rack.
(The illustration below shows the left adaptor.)
Adaptor
Portion of the rail
n
Maximum depth of adaptor : 750 mm
Minimum depth of adaptor : 595 mm
4. Attach the right and left adaptors to the rack complete-
ly using the specified six screws.
(The illustration below shows the left adaptor.)
Rack
B4 x 10
3U
Adaptor
MFS-2000 IM
B4 x 6
Adaptor
31.75
Rack
B4 x 10
31.75
Unit : mm
5. Tighten the screws (B4 x 6 : two screws each on the
right and left) for adjusting the length of the adaptor
completely (the screws that were loosened in step3).
6. Align the groove of the rack tool at the side of the equip-
ment with the rail, and slide the equipment to the rear.
n
The rack tools are hooked on the rails as shown below.
Rack tool
Rail
7. Remove the front panel. (Refer to Section 2-2.)
8. Fix the rack angles in the rack using the specified
screws.
Rack
Rack angle
B5 x 12
9. Attach the front panel to the equipment.
Rack tool
Rail
B5 x 12
Rack angle
2-7