Sony MFS-2000-C Installation Manual page 24

S103 (A-2) : Unit ID setting switch for LAN
Sets the unit ID for connecting LAN. Do not change the
setting.
Factory setting :
Bit 1 : ON
Bits 2 to 8 : OFF
S104 (A-4) : Monitor reset switch for the main
CPU
Used for maintenance purpose. Pressing this switch resets
the system while maintaining this unit through the main
CPU control terminal pin (CN103).
S401 (A-1) : System reset switch
Pressing this switch activates the system-reset and the
system restarts.
S402 (A-1) : CA-CPU reset switch
Pressing this switch resets the CA-54CFB board.
S403 (B-1): Switch setting the number of the
power supply units
Sets the number of the power supply units that are required
for this unit. Do not change the setting.
Factory setting:
Bits 1 and 2: ON
Bits 3 and 4: OFF
S901 (A-4) : Monitor reset switch for the COM CPU-1
Used for maintenance purpose. Pressing this switch resets
the system while maintaining this unit through the COM
CPU-1 control terminal pin (CN503).
S902 (A-4) : Modes setting switch for the COM CPU-1
Sets the modes of the COM CPU-1, but this switch is
currently not in use. Factory setting is all OFF.
S1101 (A-4) : Monitor reset switch for the COM CPU-2
Used for maintenance purpose. Pressing this switch resets
the system while maintaining this unit through the COM
CPU-2 control terminal pin (CN703).
S1102 (A-4) : Modes setting switch for the COM
CPU-2
Sets the modes of the COM CPU-2, but this switch is
currently not in use. Factory setting is all OFF.
2-14
<LED on the CPU-DR module> : Main CPU
Refer to <LED on the CPU-DR module> in "1. CA-54
board".
<Switch on the CPU-DR module> : Main CPU
Refer to <Switch on the CPU-DR module> in "1. CA-54
board".
<LED on the CPU-DT module> : Main CPU
Refer to <LED on the CPU-DT module> in "1. CA-54
board".
<Switch on the CPU-DT module> : Main CPU
Refer to <Switch on the CPU-DT module> in "1. CA-54
board".
<LED on the CPU-DK module> : COM CPU-1
Refer to <LED on the CPU-DK module> in "1. CA-54
board".
<Switch on the CPU-DK module> : COM CPU-1
Refer to <Switch on the CPU-DK module> in "1. CA-54
board".
: COM CPU-2
: COM CPU-2
MFS-2000 IM