Installing On The Control Console; Mks-2010 - Sony MFS-2000-C Installation Manual

<Switch>
S100 (B-1) : MAIN RESET switch
Reset switch for the entire this control panel.
S101 (B-1) : C0-RESET switch
Independent reset switch for the CTRL LAN control IC.
S102 (C-1) : C1-RESET switch
Independent reset switch for the PERIPH LAN control sub
CPU.
S103 (B-1) : Monitor reset switch for the main CPU
Reset switch that is used during maintenance of the main
CPU from the TERMINAL pin (CN101).
S104 (C-1) : Monitor reset switch for the COM0 CPU
Reset switch that is used during maintenance of the CTRL
LAN control IC from the TERMINAL pin (CN102).
S105 (D-1) : Monitor reset switch for the COM1 CPU
Reset switch that is used during maintenance of the
PERIPH LAN control IC from the TERMINAL pin
(CN103).
S106 (A-1) : Unit ID setting switch for LAN
Sets the unit ID for connecting LAN. Do not change the
setting.
Factory setting :
Bit 1 : OFF
Bits 2 to 8 : ON
S107 (A-1) : Group ID setting switch for LAN
Sets the group ID for connecting LAN.
Factory setting and in standard use :
Bit 1 : OFF
Bits 2 to 8 : ON
S108 (A-1) : STATION ID
Sets the station ID for connecting SBUS. Used to connect
the external routing switcher to the REMOTE connector.
Factory setting :
Bit 1 and bits 3 to 8 : ON
Bit 2 : OFF
1 O 1 1
2 N 2 2
3 4 3
4 8 4
5 16 5
6 32 6
7 64 7
8 128 8
UNIT ID GROUP ID
S106 S107
( indicates a knob position.)
MFS-2000 IM
O 1 1 O 1
N 2 2 N 2
4 3 4
8 4 8
16 5 16
32 6 32
CTRL 7 64
DATA 8 128
STATION ID
S108

3-5. Installing on the Control Console

3-5-1. MKS-2010

c
Be sure to install the control panel on the control console
by more than two persons. Installing it by one person may
cause backache.
The following parts supplied with the control panel are
required to install the control panel on the control console.
. Rack angle assembly (L) (R)
. Blank panel
. Screw B4 x 14 (six)
. Screw B5 x 8 (six)
. Screw B3 x 6 (four)
1. Remove the six screws (B4 x 6) of the control panel.
2. Remove the screws (B3 x 4) from the rack angle
assembly (L) and the rack angle assembly (R) respec-
tively, and remove the rack angle cover (L) and the
rack angle cover (R).
B4 x 6
B3 x 4
Rack angle
cover (L)
B3 x 4
Rack angle
assembly (L) Rack angle assembly (R)
Control panel
B4 x 6
Rack angle cover (R)
3-11