Sony MFS-2000-C Installation Manual page 27

D505 (A-2) : + + + + + 2.5 V-2
+2.5 V-2 power supply status indication.
Lit when +2.5 V-2 power is supplied.
D506 (A-3) : + + + + + 1.5 V-2
+1.5 V-2 power supply status indication.
Lit when +1.5 V-2 power is supplied.
D701 (A-5) : BUS A status LED
Lit when CPU A accesses the FPGA.
D702 (A-5) : BUS B status LED
Lit when CPU B accesses the FPGA.
D703 (A-5) : READ status LED
Lit when CPU A or B makes the read access to the FPGA.
D1001 (A-7) : BOOT DONE status LED
Lit when IC108 starts up.
D1002 (A-7) : DLKD status LED
Lit when the DLL (Delay Locked Loop) of the FPGA is
locked. If the LED does not light, the FPGA may be
defective.
D1003 (A-7) : RCB DONE status LED
Lit when the FPGA configuration is complete.
D1004 (A-7) : SYSTEM status LED
Lit when configuration is complete and FPGA reset is also
complete. If the LED does not light, the FPGA may be
defective.
D1101 (A-7) : DGB 7 A status LED
Used for design purpose.
D1102 (A-7) : DGB 6 A status LED
Used for design purpose.
D1103 (A-7) : DGB 5 A status LED
Used for design purpose.
D1104 (A-7) : DGB 4 A status LED
Used for design purpose.
MFS-2000 IM
D1201 (A-4) : DGB 7 B status LED
Used for design purpose.
D1202 (A-4) : DGB 6 B status LED
Used for design purpose.
D1203 (A-4) : DGB 5 B status LED
Used for design purpose.
D1204 (A-4) : DGB 4 B status LED
Used for design purpose.
ND1101 (A-6), ND1102 (A-6) : STATUS A LED
The status indication of the CPU A on the DVP-30 board.
ND1201 (A-3), ND1202 (A-3) : STATUS B LED
The status indication of the CPU B on the DVP-30 board.
<Switch>
S801 (A-6) : CPU A CONFIG switch
Used for maintenance purpose.
S901 (A-4) : CPU B CONFIG switch
Used for maintenance purpose.
S1101 (A-7) : SETUP A switch
Used for maintenance purpose.
S1201 (A-4) : SETUP B switch
Used for maintenance purpose.
<LED on the CPU-DR module>
Refer to <LED on the CPU-DR module> in "1. CA-54
board".
<Switch on the CPU-DR module>
Refer to <Switch on the CPU-DR module> in "1. CA-54
board".
<LED on the CPU-DT module>
Refer to <LED on the CPU-DT module> in "1. CA-54
board".
<Switch on the CPU-DT module>
Refer to <Switch on the CPU-DT module> in "1. CA-54
board".
2-17