Installation And Assembly; Installing The Dishwasher - Hanseatic WQP12-7709H User Manual

Page EN-24

Installation and assembly

Installation and assembly

Installing the dishwasher

NOTICE
Risk of damage!
Selecting the wrong screws can damage
the front panel.
Select the correct screws with the appro-
■
priate screw length.
Use the enclosed screws.
■
(c)
1. To protect the worktop against conden-
sation (c), affix the enclosed protective
film to the underside of the worktop. This
will help you minimise damage to the
worktop from the outflow of hot steam.
(g)
2. Insert the two mounting brackets (g)
into the front slots on the top of the dish-
washer so that you can screw the dish-
washer to the worktop subsequently.
3. Remove the protective films from the
side end profiles (e).
4. Affix the end profiles to the left and right
edges of the dishwasher. This will pre-
vent a crack being visible between the
dishwasher and the adjacent kitchen
cupboards.
5. Push the dishwasher into the recess.
6. To enable the dishwasher to be posi-
tioned in a level position, both the front
and back appliance feet can be adjust-
ed by up to 50 mm. The front feet are
equipped with slots. Insert a screwdriver
(e)