Connecting The Inlet Hose - Hanseatic WQP12-7709H User Manual

Connecting the inlet hose

NOTICE
Risk of damage!
The dishwasher is set up for a water
pressure of 0.4 bar to 10 bar (0.04 MPa
to 1.0 MPa). Water must always be able to
run freely into the dishwasher, otherwise
this can damage the appliance.
■ For water pressure of less than 10 bar, in-
stall a pressure reducer (in case of doubt,
seek information from the water supply
company).
■ Never connect the appliance to the wa-
ter tap or the mixing arm of a water
heater (e.g. continuous fl ow heater, pres-
sure-free boiler etc.).
■ Ensure that the inlet hose is correctly
connected and is not kinked or damaged.
■ Do not damage the inlet hose; it con-
tains electrical components. If the inlet
hose is damaged, contact our service de-
partment see „Service department" on
page EN-31).
Installation
3
Rubber
seal
For water supply, you need a water tap with
a ¾ inch screw connector.
– Screw the safety valve lock nut to the tap
hand-tight.
– Check that the connection to the water tap
is sealed. Turn on the water tap slowly and
ensure that no water is escaping. Then
close the valve again.
Page EN-23
¾ inch
Inlet hose