Hanseatic WQP12-7709H User Manual page 60

Page EN-26 Installation and assembly
(f)
7. Pull apart the two pairs of velcro
straps (f).
8. Remove the protective film from the same
type of velcro strap.
Intensive Glass
Normal 1 Hour
Rapid
ECO
On/Off
Programs
(f)
9. With the protective film removed, stick
the Velcro straps (f) to the middle of the
recessed areas on the dishwasher door.
10. Cut the positions of the Velcro straps out
of the drilling template.
11. Cut the number of mouldings used off
the drilling template.
12. Lay the supplied drilling template on the
reverse side of the front panel in such
a way that the drilling template and the
front panel are flush at the top.
9h
6h
3h
Delay
Start/Pause
(f)
13. Transfer the drill holes from the drill tem-
plate to the front panel.
14. Drill the drill holes in the indicated posi-
tions using a (Ø 2 mm) drill bit.
15. Remove the protective films from the
other Velcro straps and stick the velcro
straps to the front panel using the drilling
template.
16. Fix the front panel to the dishwasher
door using the Velcro straps (f), hold it
firmly and carefully open the door.
(k)
17. Remove the 4 screws from the inside of
the door. Screw the front panel in place
at these positions using the 4 enclosed
screws (k).
You have now fitted the front panel.