Installation; Choose A Suitable Location; Having The Outlet Hose Connected - Hanseatic WQP12-7709H User Manual

Page EN-22

Installation

Installation

Choose a suitable location

The planned location must fulfil the following
prerequisites:
– The location must be a dry and frost-safe
room with a firm ground.
– The dishwasher must be positioned be-
neath a full work surface which is joined
together with the cupboards adjacent to the
dishwasher.
– In order to install the connection pipes, the
dishwasher must be positioned near to a
washing/dishwashing basin.
– The measurements of the recess must at
least correspond to the details in the follow-
ing diagram.
90° 90 °
820 mm
820mm
580 mm
580mm
Inlet/outlet area
and electrical con-
nection.
600 mm
600 mm
CAUTION!
Risk of injury!
Improper handling of the appliance may
result in injury.
The appliance is heavy and bulky. Seek
■
the help of another person during trans-
port, installation and assembly.
If a trolley is used to move the appliance,
■
the appliance must be moved as shown
on the packaging.
Only lift the appliance as shown on the
■
packaging.
Remove all obstacles on the transport
■
route and from the installation location,
e.g. open doors and clear away objects
lying on the fl oor.
Having the outlet hose
connected
Specific technical measures are required to
connect the outlet hose (21) to the trap (si-
phon) of your washbasin/sink.
For this reason, the outlet hose may only be
connected by a professional plumber or a
member of our service department see „Ser-
vice department" on page EN-31).
Potential malfunction!
Failure to connect the appliance correctly
may cause malfunctions during operation.
Make sure that the waste water can
■
drain freely at any time. To do this, the
90° 90 °
drainage cross-section must be at least
40 mm.
Make sure that there are no kinks in or
■
damage to the outlet hose.
Make sure that the end of the hose is not
80 mm ■
80
submerged in the pumped water.
Do not extend the outlet hose or replace
■
100 mm
100
with another drainage pipe.
Connect the outlet hose's outlet as follows:
Option A:
Direct connection to the odour seal (siphon)
of your washing/dishwashing basin. The out-
let hose must be a maximum of 1000 mm
above the floor.
Option B:
Connection to a floor drain.
NOTICE
Ø 40 mm