Current Display Filter Time; 0-10V Analogue Output Low End Calibration Coefficient; 0-10V Analog Output High End Calibration Coefficient; 0-20Ma Analogue Output Low End Calibration Coefficient - Janson Controls FC100 Series Manual

Chapter 6 Description of parameter setting
P806

Current display filter time

Setting Range:0~100
This parameter setting is relevant to the stabilization of current display, and
shall not be modified in general. If the setting is too small, current display will
fluctuate.
P807

0-10V analogue output low end calibration coefficient

Setting Range:0~9999
P808

0-10V analog output high end calibration coefficient

Setting Range:0~9999
P809

0-20mA analogue output low end calibration coefficient

Setting Range:0~9999
P810
0-20mA analog output high end calibration coefficient
Setting Range:0~9999
6
The above parameters are factory default setting, normally shall not be
adjusted, otherwise it may cause abnormal operation.
98
FC100 Series User Manaul
Factory Setting:2.0
Unit:1
Unit:1
Unit:1
Unit:1
Unit:1