Indicator Lamp In The Charging Station - Husqvarna Automower 105 Operator's Manual

6.4 Indicator lamp in the charging
station
For a fully functional installation, the indicator lamp in the charging station must emit a solid green light.
If something else appears, follow the troubleshooting guide below.
If you still need help with troubleshooting, please contact your local Husqvarna
Light Cause
Green solid light
Good signals.
Green flashing The signals are good and
light
activated.
Blue flashing light
The boundary loop is not connected to
the charging station.
Break in the boundary loop.
Yellow flashing
The guide wire is not connected to the
light
charging station.
Break in the guide wire.
Red flashing light
Interruption in the charging station's an-
tenna.
Red solid light
Fault in the circuit board or incorrect
power supply in the charging station.
The fault should be rectified by an au-
thorized service technician.
36 - Troubleshooting
Action
No action required.
ECO mode is No action required. For more informa-
ECO mode , Refer to ECO mode
tion on
on page 23 .
Check that the boundary wire connec-
tor is fitted properly to the charging sta-
tion. Refer to
on page 19 .
Find out where the break is. Replace
the damaged section of the boundary
wire with a new loop wire and splice us-
ing an original coupler. Refer to
breaks in the loop wire on page 38 .
Check that the guide wire connector is
properly connected to the charging sta-
tion. Refer to
on page 19 .
Find out where the break is. Replace
the damaged section of the guide wire
with a new loop wire and splice using
an original coupler.
Contact your local Husqvarna
sentative.
Contact your local Husqvarna
sentative.
®
representative.
To install the guide wire
Find
To install the guide wire
®
repre-
®
repre-
1285 - 002 - 20.08.2019