To Charge The Battery; Adjust The Cutting Height - Husqvarna Automower 105 Operator's Manual

period must in total be according to the Standby
time table. Refer to Standby on page 26 .
Timer setting Period 1 (A): 06:00 - 17:00
Timer setting Period 2 (C): 20:00 - 23:00
Active period (A): 06:00 - 17:00
Active period (C): 20:00 - 23:00
The product operates between 06:00 and 17:00.
It starts again at 20:00 but stops at 23:00 due to
standby mode until it starts again at 06:00.
Example: A specified work area of 500 m
Operation, A + C = max. hours
Charging/Standby, B + D = min. hours 10

4.7 To charge the battery

When the product is new or has been stored for a
long period, the battery can be empty and needs
to be charged before starting. In the
the product automatically alternates between
mowing and charging.
WARNING: Only charge the product
using a charging station and a power
supply which is intended for it.
Incorrect use may result in electric
shock, overheating or leakage of
corrosive liquid from the battery.
In the event of leakage of electrolyte
flush with water and seek medical help
if it comes in contact with the eyes etc.
1. Set the Main switch to position
1285 - 002 - 20.08.2019
2. Place the product in the charging station.
3. Open the hatch and slide the product in as
far as possible to ensure proper contact
between the product and the charging
station.
4. The display shows a message that charging
is in progress.

4.8 Adjust the cutting height

The cutting height can be varied from MIN (2 cm /
0.8 in.) to MAX (5 cm / 2 in.).
Note: During the first week after a new
installation, the cutting height must be set to MAX
to avoid damaging the loop wire. After this, the
cutting height can be lowered step by step every
second week until the desired cutting height has
been reached.
4.8.1 To adjust the cutting height
1. Press the STOP button to stop the product
and open the hatch.
2. Turn the height adjustment knob to the
required position. The selected position is
indicated by the orange column on the
height adjustment indicator.
2
•
14
•
Auto mode,
3. Close the hatch.
1 .
Turn counterclockwise to increase the
cutting height.
Turn clockwise to lower the cutting
height.
1 2 3 4 5
Operation - 27