Information Messages - Husqvarna Automower 105 Operator's Manual

6.3 Information messages

Below a number of information messages are listed which may be shown in the display of the product.
®
Contact Husqvarna customer service if the same message appears often.
Message Cause
Low battery
The product cannot find the charging
station.
The guide wire is broken or not connec-
ted.
The battery is spent.
The charging station's antenna is de-
fective.
Settings restored
Confirmation that a
tings has been carried out.
Guide not found
The guide wire is not connected to the
charging station.
Break in the guide wire.
The guide wire is not connected to the
boundary loop.
Guide calibration
The product has failed to calibrate the
failed guide wire.
Guide calibration
The product has succeeded to calibrate
accomplished
the guide wire.
1285 - 002 - 20.08.2019
Action
Check that the charging station and the
guide wire are installed in accordance
with the instructions. Refer to
the guide wire on page 19 .
Find out where the break is and rectify
it.
Replace the battery. Refer to
move the battery on page 41 .
Check if the indicator lamp in the
charging station flashes red. Refer to
Indicator lamp in the charging station
on page 36 .
Reset all user set-
This is normal. No action required.
Check that the guide wire connector is
tightly connected to the charging sta-
tion. Refer to
on page 19 .
Find out where the break is. Replace
the damaged section of the guide wire
with a new loop wire and splice using
an original coupler.
Check that the guide wire is connected
correctly to the boundary loop. Refer to
To install the guide wire on page 19 .
Check that the guide wire is installed
according to the instructions. Refer to
To examine where to put the guide wire
on page 17 . Also, check that the mini-
mum distance to the left of the guide
wire is met. Refer to
to put the guide wire on page 17 .
No action required.
To install
To re-
To install the guide wire
To examine where
Troubleshooting - 35