Troubleshooting; Introduction - Troubleshooting; Fault Messages - Husqvarna Automower 105 Operator's Manual

Hide thumbs Also See for Automower 105:
Table of Contents

Advertisement

6.1 Introduction - troubleshooting

In this chapter, faults and symptoms are described and can guide you if the product does not operate
as expected. More suggestions for steps to take in the event of malfunction or symptoms can be found
on www.husqvarna.com.

6.2 Fault messages

Below a number of fault messages are listed which may be shown in the display of the product.
®
Contact Husqvarna
customer service if the same message appears often.
Message
Cause
Wheel motor
Grass or other object has wrapped
blocked, left/right
around the drive wheel.
Cutting system
Grass or other object has wrapped
blocked
around the blade disc.
The blade disc lies in a pool of water.
Trapped
The product has got caught in some-
thing.
The product is stuck behind a number
of obstacles.
Outside working
The boundary wire connections to the
area
charging station are crossed.
The boundary wire is too close to the
edge of the work area.
The work area slopes too much by the
boundary loop.
The boundary wire is laid in the wrong
direction around an island.
Disturbances from metal objects (fen-
ces, reinforcement steel) or buried ca-
bles close by.
The product finds it hard to distinguish
the signal from another product installa-
tion close by.
1285 - 002 - 20.08.2019

6 Troubleshooting

Action
Check the drive wheel and remove the
grass or other object.
Check the drive wheel and remove the
grass or other object.
Move the product and prevent the col-
lection of water in the work area.
Free the product and rectify the reason
for it becoming trapped.
Check if there are any obstacles which
make it hard for the product to move on
from this location.
Check that the boundary wire is con-
nected correctly.
Check that the boundary wire has been
laid according to the instructions. Refer
to
18 .
Try moving the boundary wire.
Place the product in the charging sta-
tion and generate a new loop signal.
To install the boundary wire on page
Troubleshooting - 31

Advertisement

Table of Contents
loading

Table of Contents