Husqvarna Automower 105 Operator's Manual page 33

Message Cause
Upside down
The product is leaning too much or has
turned over.
Needs manual The product is set to the
charging area operating mode.
Next start hh:mm
The timer setting prevents the product
from operating.
The rest period is in progress. The
product has an inbuilt standby period
according to the Standby time table.
The clock on the product is not correct.
Today's mowing
The rest period is in progress. The
completed
product has an inbuilt standby period
according to the Standby time table.
Lifted
The lift sensor has been activated as
the product has become trapped.
Collision sensor
Product body can not move freely
problem, front/rear
around its chassis.
Wheel drive prob-
Grass or other object is wrapped
lem, right/left
around the drive wheel.
Safety function
Temporary electronic or firmware rela-
faulty
ted issue in the product.
Electronic problem
Loop sensor prob-
lem, front/rear
Charging system
problem
Tilt sensor prob-
lem
Temporary prob-
lem
1285 - 002 - 20.08.2019
Action
Turn the product the right way up.
Secondary Place the product in the charging sta-
tion. This behavior is normal and no ac-
tion is required.
Change the timer settings. Refer to
do the timer settings on page 20 .
This behavior is normal and no action
is required.
Set the time. Refer to
& Date on page 23 .
This behavior is normal and no action
is required.
Free the product.
Check that the product body can move
freely around its chassis.
If the problem remains, the message
requires action by authorized service
technician.
Clean the wheels and around the
wheels.
Restart the product.
If the problem remains, the message
requires action by authorized service
technician.
To
To set the Time
Troubleshooting - 33