Husqvarna Automower 105 Operator's Manual page 32

Message Cause
Empty battery
The product cannot find the charging
station.
The guide wire is broken or not connec-
ted.
The battery is spent.
The charging station's antenna is de-
fective.
Wrong PIN code
Wrong PIN code has been entered.
Five attempts are permitted, and the
keypad is then blocked for five minutes.
No drive
The product has got caught in some-
thing.
The work area includes a steep slope.
The guide wire is not laid at an angle
on a slope.
Wheel motor over-
The product has got caught in some-
loaded, right/left thing.
Charging station
The contact between the charging
blocked
strips and contact strips may be poor
and the product has made a number of
attempts to charge.
An object is obstructing the product.
The charging station is tilted or bent.
Stuck in charging There is an object in the way of the
station
product preventing it from leaving the
charging station.
32 - Troubleshooting
Action
Check that the charging station and the
guide wire are installed in accordance
with the instructions. Refer to
the guide wire on page 19 .
Find out where the break is and rectify
it.
Replace the battery. Refer to
move the battery on page 41 .
Check if the indicator lamp in the
charging station flashes red. Refer to
Indicator lamp in the charging station
on page 36 .
Enter the correct PIN code. Contact
®
Husqvarna customer service if you
forget the PIN code.
Free the product and rectify the reason
for the lack of drive. If it is due to wet
grass, wait until the lawn has dried be-
fore using the product.
Steep slopes should be isolated. Refer
To examine where to put the guide
to
wire on page 17 .
If the guide wire is laid on a slope, it
must be laid at an angle across the
To install the guide wire
slope. Refer to
on page 19 .
Free the product and rectify the reason
for the lack of drive. If it is due to wet
grass, wait until the lawn has dried be-
fore using the product.
Put the product in the charging station
and check that the charging strips and
contact strips make good contact.
Remove the object.
Confirm that the charging station is
placed on a fully flat and horizontal
ground. The charging station must not
be tilted or bent.
Remove the object.
1285 - 002 - 20.08.2019
To install
To re-