Inserting The S8300 Media Server Module - Avaya G350 Installation Manual

Inserting the S8300 Media Server module

CAUTION:
Hold media modules only by the edges to avoid damage from static electricity. Do not
touch the top or bottom of the circuit board. If possible, wear a wrist-strap and use an anti-
static bag.
CAUTION:
The connector pins can be bent or damaged if the module is handled roughly, or if
misaligned and then forced into position.
CAUTION:
Separate ESD paths to the chassis ground connect to the media modules at the spring-
loaded captive screws. Use a screw driver to ensure the captive screws are securely
tightened to prevent damage to the equipment.
The S8300 can only be inserted in slot V1 on the left side of the G350 Media Gateway.
To insert the S8300 Media Server module
1
Remove the plate between slots V1 and V2, labelled "Remove before removing or inserting
S8300 module."
2
Remove the blank plate from slot V1.
3
Position the media module squarely before the V1 bay opening and engage both sides of the
module in the interior guides.
4
Slide the S8300 module slowly into the chassis, maintaining an even pressure to assure that the
module does not become twisted or disengaged from the guides.
Figure 5: Inserting the S8300 media server module.
Installation of the G350 Media Gateway
December 2003
Installing the Avaya G350 Media Gateway
Step 2: Install the media modules
25