Inserting The S8300 Server Module - Avaya G250 Installing And Upgrading

Installing the Avaya G250 Media Gateway

Inserting the S8300 Server module

The S8300 can only be inserted in slot V1 on the left side of the G250 Media Gateway.
ELECTROSTATIC ALERT:
Hold media modules only by the edges to avoid damage from static electricity. Do
ELECTROSTATIC ALERT:
not touch the top or bottom of the circuit board. If possible, wear an anti-static
wrist-strap and use an anti-static bag.
!
CAUTION:
The connector pins can be bent or damaged if the module is handled roughly, or if
CAUTION:
misaligned and then forced into position.
!
CAUTION:
Separate ESD paths to the chassis ground connect to the media modules at the
CAUTION:
spring-loaded captive screws. Use a screwdriver to ensure the captive screws are
securely tightened to prevent damage to the equipment.
1. If you are installing an S8300A or S8300B, remove the plate above slot V1, labelled
"Remove before removing or inserting S8300 module."
2. Remove the blank plate from slot V1.
3. Position the media module before the V1 bay opening and engage both sides of the
module in the interior guides.
4. Slide the S8300 module slowly into the chassis, maintaining an even pressure to assure
that the module does not become twisted or disengaged from the guides.
Figure 6: Inserting the S8300 Server module.
5. Apply firm pressure to engage the connectors.
The connector has different length pins. The long pins will engage first to provide
grounding. Medium length and short pins will provide power and signal.
32 Installing and Upgrading the Avaya G250 Media Gateway