Set Up A Misphere System - Barco MiSPHERE Installation Manual

5. Setup process of a MiSPHERE system

5.1 Set up a MiSPHERE system

Setup process
1. The first stage in the process is the creation of the MiSPHERE strings. See detailed procedure "Create a MiSPHERE string",
page 32. Ensure that the output socket of the last MiSPHERE unit is sealed up with an end cap.
Warning: The length of the MiSPHERE string is limited, maximum 64 MiSPHERE units per string.
63
64
Image 5-1
2. The second stage in the process is the suspension of the MiSPHERE strings. See detailed procedure "Hang up a MiSPHERE
string", page 34. Note that the spacing between the strings is variable.
Image 5-2
3. The third stage in the process is the installation of the MiSPHERE control boxes. One MiSPHERE control box needs to be
installed per four MiSPHERE strings. Note that the MiSPHERE control box has four output ports, which has to be placed within
the range of the MiSPHERE primary cables connected with the MiSPHERE strings. The MiSPHERE control box is attached
to a mounting plate which enable the use of universal doughty clamps for easy installation. See detailed procedure "Install the
MiSPHERE control box", page 36.
Image 5-3
28
5
61
62
1
2
3
4
R5976941 MISPHERE 03/01/2006