Table of Contents
Advertisement
4. The next stage in the process is the installation of the digitizer and the realization of the data cabling of the MiSPHERE control
boxes. For installation guidelines about the digitizer, see manual of the used digitizer. To realize the data cabling, see chapter
"Data cabling of MiSPHERE control boxes", page 39.
Caution:
Do not forget to place a dummy data plug upon the data output socket of the last MiSPHERE control box in the data
chain.
OUT
IN
Image 5-4
5. The next stage in the process is the installation of the power box(es) and the realization of the power cabling of the MiSPHERE
control boxes. For installation guidelines about the power box(es), see manual of the used power box(es). To realize the power
cabling, see chapter "Power cabling of MiSPHERE control boxes", page 38.
Warning: To protect against risk of fire by overloading of power cables, the amount of MiSPHERE control boxes per power
source cable is limited. Never connect more than 3 MiSPHERE control boxes with one power source cable.
Caution:
Do not forget to place a dummy power plug upon all unused power output sockets of the MiSPHERE control boxes.
OUT
IN
Image 5-5
6. The second last stage in the process is the installation of the control software (Director toolset). See software installation proce-
dure described in the manual of the control software.
Image 5-6
7. The last stage in the process is to energize the MiSPHERE system and start up the control software.
R5976941 MISPHERE 03/01/2006
OUT
OUT
IN
IN
OUT
OUT
IN
IN
5. Setup process of a MiSPHERE system
OUT
OUT
IN
IN
OUT
OUT
IN
IN
OUT
OUT
IN
IN
OUT
OUT
IN
IN
29
Advertisement
Table of Contents
