HP 3500yl Series Access Security Manual page 755

HP Switch(config)# show key-chain Networking2
Chain - Networking2
Key | Accept Start GMT
--- + ----------------- ----------------- ----------------- -----------------
1 | 01/03/90 13:59:20 06/17/11 08:00:00 01/03/90 13:59:20 06/17/11 08:00:00
2 | 06/18/11 08:00:00 06/19/11 08:10:00 06/18/11 08:00:00 06/19/11 08:00:00
3 | 06/19/11 08:00:00 06/20/11 08:10:00 06/19/11 08:00:00 06/20/11 08:00:00
4 | 06/20/11 08:00:00 06/21/11 08:10:00 06/20/11 08:00:00 06/21/11 08:00:00
5 | 06/21/11 08:00:00 06/22/11 08:10:00 06/21/11 08:00:00 06/22/11 08:00:00
Figure 16-4. Display of Time-Dependent Keys in the Key Chain Entry
Accept Stop GMT
You can use show key-chain to display the key status at the time the command
is issued. Using the information from the example configuration in figures
16-3 and 16-4, if you execute show key-chain at 8:05 on 01/19/03, the display
would appear as follows:
HP Switch(config)# show key-chain
Key Chains
Chain Name
-------------------------------- ---- ------ -------
Networking1
Networking2
Figure 16-5. Status of Keys in Key Chain Entry "Networking2"
The "Networking1" key chain entry is a time-independent key and will not
expire. "Networking2" uses time-dependent keys, which result in this data:
Expired = 1 Key 1 has expired because its lifetime ended at 8:10 on 01/18/03, the
previous day.
Active = 2 Key 2 and 3 are both active for 10 minutes from 8:00 to 8:10 on 1/19/03.
Keys 4 and 5 are either not yet active or expired. The total number of keys is 5.
Configuring Key Chain Management
Send Start GMT
Keys Active Expired
1 0
5 1
Key Management System
Send Stop GMT
1
0
16-7