HP 3500yl Series Access Security Manual page 199

HP Switch
(config)# show port-access mac-based clients 1 detailed
Port Access MAC-Based Client Status Detailed
Client Base Details :
Port
Session Status : authenticated
Username
IP
Access Policy Details :
COS Map
Untagged VLAN
Tagged VLANs
RADIUS-ACL List :
deny in udp from any to 10.2.8.233 CNT
Hit Count: 0
permit in udp from any to 10.2.8.233 CNT
Hit Count: 0
deny in tcp from any to 10.2.8.233 CNT
Hit Count: 0
permit in tcp from any to 10.2.8.233 CNT
Hit Count: 0
permit in tcp from any to 0.0.0.0/0 CNT
Hit Count: 0
Figure 4-42. Example of show port-access mac-based clients detail Command Output
Syntax: show port-access mac-based clients <port-list> detailed
Displays detailed information on the status of MAC-
authenticated client sessions on specified ports. Show
session status, name, and address for each MAC-
authenticated client on the switch. The IP address displayed
is taken from the DHCP binding table (learned through
DHCP snooping).The following can appear if the client's IP
address is not available:
n/a—DHCP snooping is not enabled on the switch; n/a is
displayed for a client's IP address.
n/a-IPv6—a web-authenticated client uses an IPv6 address.
n/a-no info—DHCP snooping is enabled but no MAC-to-IP
address binding for a client is found in the DHCP binding
table.
: 1
: client1
: n/a
: 12345678
: 4006
: 1, 3, 5, 6, 334, 4001
Configuring MAC Authentication on the Switch
Session Time(sec) : 6
MAC Address
In Limit %
Out Limit %
Web and MAC Authentication
: 0010b5-891a9e
: 98
: 100
4-67