HP 3500yl Series Access Security Manual page 668

Configuring Port-Based and User-Based Access Control (802.1X)
Displaying 802.1X Configuration, Statistics, and Counters
13-56
Syntax: show port-access authenticator [port-list]
[config | statistics | session-counters | vlan | clients | clients detailed
—Continued—
• Untagged VLAN: VLAN ID number of the untagged VLAN
used in client sessions. If the switch supports MAC-based
(untagged) VLANs, MACbased is displayed to show that
multiple untagged VLANs are configured for
authentication sessions.
• Tagged VLANs: Are tagged VLANs (statically configured or
RADIUS-assigned) used for authenticated clients?
Yes or No
• Port COS:
Yes - Client-specific CoS (Class of Service) values are
applied to more than one authenticated client on the port.
No - No client-specific CoS values are applied to any
authenticated client on the port.
<cos-value>- Numerical value of the CoS (802.1p
priority) applied to inbound traffic from one
authenticated client. For client-specific per-port CoS
values, enter the show port-access web-based clients detailed
command.
• % In Limit: Inbound rate limit applied.
• RADIUS ACL: Are RADIUS-assigned ACLs used for
authenticated clients? Yes or No
• Cntrl Dir: Directions in which flow of incoming and
outgoing traffic is blocked on 802.1X-aware port that has
not yet entered the authenticated state:
Both: Incoming and outgoing traffic is blocked on port until
authentication occurs.
Only incoming traffic is blocked on port before
In:
authentication occurs. Outgoing traffic with unknown
destination addresses is flooded on the unauthenticated
802.1X-aware port.