Resequencing The Aces In An Acl - HP 3500yl Series Access Security Manual

Figure 10-28 illustrates the process for deleting an ACE from a list:
(config)# show run
HP Switch
. . .
ACL Before Deleting an ACE
ip access-list standard "My-List"
10 permit 10.10.10.25 0.0.0.0
15 deny 10.10.10.1 0.0.0.255
20 permit 10.20.10.117 0.0.0.0
30 deny 10.20.10.1 0.0.0.255
40 permit 0.0.0.0 255.255.255.255
exit
(config)# ip access-list standard My-List
HP Switch
(config-std-nacl)# no 20
HP Switch
(config-std-nacl)# show run
HP Switch
. . .
ACL After Deleting the ACE at Line 20
ip access-list standard "My-List"
10 permit 10.10.10.25 0.0.0.0
15 deny 10.10.10.1 0.0.0.255
30 deny 10.20.10.1 0.0.0.255
40 permit 0.0.0.0 255.255.255.255
exit
Figure 10-28. Example of Deleting an ACE from Any ACL

Resequencing the ACEs in an ACL

This action reconfigures the starting sequence number for ACEs in an ACL,
and resets the numeric interval between sequence numbers for ACEs config-
ured in the ACL.
Syntax: ip access-list resequence < name-str | 1 - 99 | 100 - 199 >
Resets the sequence numbers for all ACEs in the ACL.
< starting-seq-# > : Specifies the sequence number for the first
ACE in the list. (Default: 10; Range: 1 - 2147483647)
< interval > : Specifies the interval between sequence numbers
for the ACEs in the list. (Default: 10; Range: 1 - 2147483647)
1. To view the current sequence numbering in an ACE, use show run or show
access-list < name-str | 1 - 99 | 100-199 >.
2. Use the command syntax (above) to change the sequence numbering.
IPv4 Access Control Lists (ACLs)
Editing an Existing ACL
This command enters the
"Named-ACL" (nacl)
context for "My-List".
This command deletes the
ACE at line 20.
The ACE at line 20 has been
removed.
< starting-seq-# > < interval >
10-91