Wake-On-Lan Traffic - HP 3500yl Series Access Security Manual

Switch software
Hide thumbs Also See for 3500yl Series:
Table of Contents

Advertisement

Configuring Port-Based and User-Based Access Control (802.1X)
Configuring Switch Ports as 802.1X Authenticators
N o t e
13-28
Prerequisite. As documented in the IEEE 802.1X standard, the disabling of
incoming traffic and transmission of outgoing traffic on an 802.1X-aware
egress port in an unauthenticated state (using the aaa port-access controlled-
directions in command) is supported only if:
The port is configured as an edge port in the network using the spanning-
tree edge-port command.
The 802.1s Multiple Spanning Tree Protocol (MSTP) or 802.1w Rapid
Spanning Tree Protocol (RSTP) is enabled on the switch. MSTP and RSTP
improve resource utilization while maintaining a loop-free network.
For information on how to configure the prerequisites for using the aaa port-
access controlled-directions in command, see Chapter 4, "Multiple Instance
Spanning-Tree Operation" in the Advanced Traffic Management Guide.
Syntax:
aaa port-access <port-list > controlled-directions <both | in>
both (default): Incoming and outgoing traffic is blocked on
an 802.1X-aware port before authentication occurs.
in: Incoming traffic is blocked on an 802.1X-aware port
before authentication occurs. Outgoing traffic with
unknown destination addresses is flooded on
unauthenticated 802.1X-aware ports.

Wake-on-LAN Traffic

The Wake-on-LAN feature is used by network administrators to remotely
power on a sleeping workstation (for example, during early morning hours to
perform routine maintenance operations, such as patch management and
software updates).
The aaa port-access controlled-direction in command allows Wake-on-LAN
traffic to be transmitted on an 802.1X-aware egress port that has not yet
transitioned to the 802.1X authenticated state; the controlled-direction both
setting prevents Wake-on-LAN traffic to be transmitted on an 802.1X-aware
egress port until authentication occurs.
Although the controlled-direction in setting allows Wake-on-LAN traffic to
traverse the switch through unauthenticated 802.1X-aware egress ports, it
does not guarantee that the Wake-on-LAN packets will arrive at their destina-
tion. For example, firewall rules on other network devices and VLAN rules
may prevent these packets from traversing the network.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents