Configuring Connection-Rate Filtering; Global And Per-Port Configuration - HP 3500yl Series Access Security Manual

Note

Configuring Connection-Rate Filtering

Command

Global and Per-Port Configuration

connection-rate-filter sensitivity < low | medium | high | aggressive >
filter connection-rate < port-list > < notify-only | throttle | block >
show connection-rate-filter < blocked-host >
Unblocking Hosts
connection-rate-filter unblock
As stated previously, connection-rate filtering is triggered by inbound IP
traffic exhibiting a relatively high incidence of IP connection attempts from a
single source.
Global and Per-Port Configuration
Use the commands in this section to enable connection-rate filtering on the
switch and to apply the filtering on a per-port basis. (You can use the ACL
commands in the next section to adjust a filter policy on a per-vlan basis to
avoid filtering traffic from specific, trusted source addresses.)
Virus Throttling (Connection-Rate Filtering)
Configuring Connection-Rate Filtering
Page
3-10
3-11
3-17
3-9