Network Stack Configuration; Chipset - DFI CS331-C246 User Manual

CS331-C246/Q370
► Advanced

Network Stack Configuration

This section is used to configure the Network Stack settings.
Network Stack
This section is used to enable or disable UEFI network stack. When Network Stack is set to
enabled, several options will appear for configuration.
Aptio Setup Utility - Copyright (C) 2019 American Megatrends, Inc.
Advanced
Network Stack [Enabled]
Ipv4 PXE Support [Disabled]
Ipv6 PXE Support [Disabled]
PXE boot wait time 0
Media detect count 1
Version 2.20.1271. Copyright (C) 2019 American Megatrends, Inc.
Ipv4 PXE Support
Enable or disable IPv4 PXE boot support. If disabled, IPv4 PXE boot support will not be avail-
able.
Ipv6 PXE Support
Enable or disable IPv6 PXE boot support. If disabled, IPv6 PXE boot support will not be avail-
able.
PXE boot wait time
Set the wait time in seconds to press ESC key to abort the PXE boot. Use either +/- or nu-
meric keys to set the value.
Media detect count
Set the number of times the presence of media will be checked. Use either +/- or numeric
keys to set the value.
Chapter 3 - BIOS

► Chipset

Enable/Disable UEFI
Network Stack
Select Screen
→←:
Select Item
↑↓:
Enter: Select
+/ - : Change Opt.
F1: General Help
Graphics Configuration
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
Primary Display
Select which of IGFX/PEG/PCI Graphics device to be the primary display.
Internal Graphics
Keep IGFX enabled based on the setup options.
44
Aptio Setup Utility - Copyright (C) 2019 American Megatrends, Inc.
Main Advanced Chipset Security Boot Save & Exit
Graphics Configuration

PEG Port Configuration

PCH-IO Configuration

Version 2.20.1271. Copyright (C) 2019 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2019 American Megatrends, Inc.
Chipset
Graphics Configuration
[Auto]
Primary Display
[Auto]
Internal Graphics
Version 2.20.1271. Copyright (C) 2019 American Megatrends, Inc.
www.dfi.com
Graphics Configuration
Select Screen
→←:
Select Item
↑↓:
Enter: Select
+/ - : Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
Initial priority :
AUTO: PEG->PCIe->PCI-
>IGFX
IGFX: IGFX->PEG-
>PCIe->PCI
PEG: PEG->PCIe->PCI-
>IGFX
PCI: PCI->PCIe->PEG-
>IGFX
Select Screen
→←:
Select Item
↑↓:
Enter: Select
+/ - : Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit